KleenSteam II Single

Everpure EV979721A | Our#: 111957

KLEENSTEAM II SINGLE (9797-21) same as old 9797-00


  • A total system delivering high quality filtered water with scale inhibition and deliming capabilities
  • New dual cartridge design provides enhanced performance for low or high flow capacity steamers and flexibility for expanding to meet future needs
  • Fine filters incoming water to improve the performance, maximize energy efficiency and increase the life of steam equipment
  • Reduces chlorine-induced corrosion
  • System is simple to install, operate and maintain
  • Easy deliming with ScaleKleen, which is fed into the boiler through the SR-X bowl without use of hazardous chemicals or special piping
  • Long lasting SS-10 cartridge is more effective in higher alkalinty/hardness/TDS/temperature installations
  • Sophisticated Hydroblend compound prevents limescale formation in high temperature steam applications

 Installation Tips

  • Choose a mounting location suitable to support the full weight of the system when operating
  • Use minimum 1/2" inlet water line (3/4" preferred)
  • Connect the system to the boiler feed water line only! Do not connect to the condenser water line!
  • Install vertically with cartridges hanging down
  • Allow 2-1/2" clearance below the cartridge for easy cartridge replacement
  • Flush cartridges by running water through filter for five minutes at full flow

 Operation Tips

  • Change 7CB5 cartridge on a regular 6 month preventative maintenance program, when capacity is reached or when pressure falls below 10 psi
  • Change SS-10 cartridge before HydroblendT compound is completely used up
  • Service flow rate must not exceed 2.5 gpm for single cartridge systems or 5.0 for dual cartridge systems
  • Always flush the filter cartridge at time of installation and cartridge change
  • Use for periodic deliming as needed by installing the dip tube assembly in place of the SS-10 and dissolving Scale Kleen in SR-X housing. Full deliming instructions are provided with the system



For commercial steam applications

For use with foodservice steamer and combi-oven applications

The Kleensteam II Single System is shipped with one 7CB5 cartridge (for first filter head) and one filter head plug installed in the second filter head.

Capacity is expandable by adding a second 7CB5 cartridge.




Overall Dimensions: 25.5"H x 20.5"W x 7"D

Inlet connection: 3/4" FNPT

Outlet connection: 3/4" FNPT

Service Flow Rate: Maximum 2.5 gpm (9.5 Lpm) - single cartridge

Pressure Requirements: 10 - 125 psi (0.7 - 8.6 bar), non-shock

Maximum water temperature at inlet: 100F (38C)

Alkalinity range: 2 to 12 grains per gallon

No electrical connection required

Shipping Weight:  26 lbs.

Operating Weight:  32 lbs.